6
7
WPC-18000
Owner’s Manual
Installation
MOVING THE UNIT
PLUGGING IN THE UNIT
Unlock the casters and push the unit using the side handles to a flat, level surface and set the
caster brakes to the locked position.
Check the prongs and surface of the power cord plug for dust/dirt. If dust and / or dirt are
present, wipe off with a clean, dry cloth.
Check the power cord, plug and prongs for any damages
If you suspect any damage or deterioration, contact a qualified technician to perform replace
-
ment or repair
NOTE:
Make sure the AC outlet is free of dirt, dust, oil, water, or any other foreign material. The
unit is equipped with an approved NEMA plug configuration. The appropriate outlet must
be used for each plug type.
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
Do not use the unit in explosive environments or in areas where flammable
gas leakage may occur.
Do not use the unit in areas where it will be exposed to rain or water.
Do not use the unit in a corrosive atmosphere.
Do not use the unit above 18°C(64°F) ~ 45°C(113°F).
Do not install the unit on uneven or sloping surface. The unit may roll or
topple over even if the casters are set to the locked position.
If the power cord or plug is damaged, repair should only be performed by
qualified electrical personnel.
Do not connect / disconnect the power cord or attempt to operate buttons
with wet hands. This could result in electrical shock.
