7
Owner’s Manual
WPH-3000
Operation
CONTROL PANEL
1
. POWER BUTTON
- Activates unit when POWER BUTTON is pressed for 2 seconds. If POWER BUTTON is pressed for 2
seconds during operation, unit stops.
2
. FAN SPEED BUTTON
- Changes fan speed from (AUTO) to (MANUAL) when pressed.
- When MANUAL lamp is on, change fan speed between 1 and 6 step by pressing UP/DOWN BUTTONS.
- When AUTO lamp is on, fan speed is changed automatically between 1 and 6 step. When COOL mode,
fan speed starts in high speed. When HEAT mode, fan speed starts in low speed.
3
. TEMP SELECT BUTTON
- Choose temperature sensor by pressing this button shortly.
- When IN lamp is on, inlet temperature sensor works so it is used to control inside of a room.
- When OUT lamp is on, outlet temperature sensor works so it is used to provide cool air or hot air
directly to people or material.
- By pressing this button for 2 seconds, SET lamp will be on and SET mode activates. Then set the
target temperature by pressing UP/DOWN BUTTONS. After setting the target temperature, press
TEMP SELECT BUTTON for 2 seconds and SET lamp will be off and setting temperature will be
memorized.
When power is connected
POWER
lamp will be on.
CURRENT
POWER
FAN SPEED
AUTO MANUAL
IN
OUT
SET
AUTO COOL HEAT
POWER
TEMP SELECT
MODE
TEMP
TARGET
TEMP
1
2
3
4
5
9
6
8
7
Figure 9
Note :
It will take more than 10 seconds to start fans.
