OPERATION
BT-218T HOAGIE BUN TOASTER
NORMAL OPERATION
1. Place toaster on a non-combustible countertop.
2. Plug into a 120 Volt 15 Amp receptacle.
3. Press POWER SWITCH to the
ON
position. Indicator light on
switch will glow when toaster is energized.
The RIGHT digital display will display the actual temperature for
15 seconds.
4. Allow toaster to pre-heat for 15 minutes before using. Press the
SET button of the RIGHT controller to view the actual temperature.
Temperature will be displayed for 15 seconds, then the display will
return to 00:00.
5. Butter inside of hoagie bun, being careful to not open bun too far.
6. Position bun on toaster blade right or left side: cut edge down,
hinge edge up.
7. Press the appropriate timer start switch. Display will countdown
from time remaining.
8. When the display reads 00:00, An audible alarm will sound for 4
seconds. Remove bun from toaster blade.
PROGRAMMING THE CONTROLLER
NOTE:
RIGHT controller controls temperature for both sides.
Set TEMPERATURE
•
On right controller, press and hold the SET button.
•
Press the UP ARROW button to raise the temperature setting.
Press the DOWN ARROW button to lower the temperature setting.
•
Release the SET button to complete the change.
•
Maximum temperature is 550ºF.
Set TIME
•
On either controller, press and hold UP ARROW and DOWN
ARROW buttons simultaneously for 3 seconds to enter the TIME
mode. The display will read “tMr”.
•
Press and hold the SET button.
•
Press the UP ARROW button to raise the time setting. Press the
DOWN ARROW button to lower the lower setting.
•
Release the SET button. Press and hold UP ARROW and DOWN
ARROW buttons simultaneously for 3 seconds to complete the
change. The display will read :00:00”.
5
WARNING:
Burn Hazard
The cooking blade will be
very hot during operation and
will cause serious burns if
touched.
CAUTION:
Hot Surface
Exposed surfaces can be hot
to the touch and may cause
burns.
NOTE: Toaster blade will
accommodate two 9” hoagie
buns at one time. Buns may
be toasted and removed
separately.
ERROR CODES
The controller will show an
error code on the digital
display in the event of certain
malfunctions.
Contact your Authorized
Wells Service Agency if an
error code cannot be cleared
by turning the power switch
off then back on.
Er1 Reversed thermocouple
Er2 Sensor type mismatch or
open thermocouple
Er3 Sensor type mismatch
Er4 Open thermocouple, bad
connection or broken
wire
Er5 Electrical noise
