background image

WDH 10T / WDH 20T

     5-7

Note

Observe the Operating Instructions of your control unit when setting

and switching the SETBACK and AUTO-OFF functions on and off.

4.2

 

Switching valve control with Switching Tool

Stand on/off (WAD101)

When operating a soldering iron with inert gas and when using the

Switching Tool Stand, the valve control must be set at the WAD 101

control unit. Two switching conditions are possible:

 

A-1: the valve control is switched on. The valve is activated by the

Switching Tool Stand with the ON/OFF function. In this operating

condition, the SETBACK function "OFF" is not available.

 

A-0: the valve control is switched off. The SETBACK function is

available without restrictions.

Note

Observe the Operating Instructions of your control unit when

setting the valve control function.

5

 

WDH 10T /  WDH 20T: maintenance and

care

The sponge should be cleaned regularly to remove solder residue

using distilled water only.

6

 

Fault messages and corrective actions

Message/Symptom

Possible cause

Corrective measures

SETBACK time on the

soldering station is activated

Soldering iron only switches off

after the set time:

Z

 

Set the SETBACK time on the

soldering station to 0.

Soldering iron does not

switch off after being placed

in the holder

The holder is not correctly

connected

Z

 

Check connecting cable
-

 

 Holder cable to  soldering

station

-

 

Soldering iron to holder

Soldering iron no longer

switches on after removal

from holder

Movable funnel or shift linkage

is jammed

Check funnel and shift linkage

Summary of Contents for WDH 10T








Reviews: