5
STYLE 2
1.
Loosen set screws with supplied hex key.
2.
Pull tip from gun.
3.
Slide new tip into gun until it bottoms out.
4.
Tighten set screw.
TROUBLE SHOOTING:
Soldering Gun doesnt heat properly:
If your Weller
®
Soldering Gun appears to be heating, but not hot enough to
perform the job, try loosening and re-tightening the tip. It may become
necessary to clean the connecting area of the tip ends with sandpaper or
possibly install a new tip.
(Refer to Replacing Tips section).
A good
electrical connection between the tip and the soldering gun is essential for the
tool to heat properly.
Light bulbs dont light up:
Try tightening the bulbs in the sockets. If problem still persists, then
replacement bulbs can be purchased. (Part # 7333).
Summary of Contents for D650
Page 3: ...3 4 ...
