Operating instructions Medial
__________________________
4
1.1 General
Please read these operating instructions carefully in order to prevent damage during assembling and
before placing the health care bed with slatted frame into operation
Only accessories from Fa. Müller Kranken- und Pflegeeinrichtungen Werner Mühle GmbHwhich were
delivered with the bed (accessory kit) or were ordered as special equipment are to be used. The list for
special equipment is in 5.0
The user has to assure oneself of the good order and condition of the health care bed. On long-term
application (every 12 months) or reuse after storage it is necessary to check its functions and look for
visible damages.
The health care beds are produced following DIN EN 1970 – 2000 (standard for health care beds)
as well as
DIN EN 60601-2-38 (= standard for nursing beds / in dependence on)
The drive units comply with the EN 60601-1 specification.
Certain constellations, like positioning the bed next to other electrical equipment – like radio or
television - may lead to electro-magnetic interferences. In this case remove the devices or change the
position of the bed.
Storage condition:
The health care bed should always be used under the following conditions:
Storage temperature: + 10° to max. + 40 ° C
Relative air humidity
: 30 to 75%
Air pressure : 700 – 1000 Hektopascal
When your bed has the special feature „Trendelenburg-position“it is possible to move the bed
with the charged accumulator battery only (without any further external power supply)
This shall secure the prone positioning in case of power blackout while Trendelenburg position.
If the bed is to bed stored for a longer period, a patient is transported in the bed or the power
supply is cut for security reasons it is absolutely necessary to unplug the connection from the
accumulator battery to the laying surface motor in order to prevent any unwanted displacing of
the health care bed. (see photo)
1. Remove the cap with a standard Phillips head screw driver
2. Here the accumulator battery is connected
!
3. Unplug the plug and disconnect the accumulator power supply!
Finally you have to screw the cap back on the multiway connector!
1.2 Symbols in use - Illustration