Parts list
Prior to assembly, read instructions carefully and check all the parts against part list.
This product
MUST NOT
being used if power cable is damaged. If there is damage, it must be replaced by
manufacturer, its service agent or similar qualified persons in order to avoid hazard.
For ease of assembly only loosely tighten bolts and then tighten fully when assembly is complete.
WARNING!
DO NOT
over tightening bolts; only tighten with moderate pressure to avoid damaging bolts or
components of the heater.
ASSEMBLY DIAGRAM
Wall assembly instructions
1.
Mark the hole positions using a pencil and drill 4 holes into a suitably strong exterior wall by positioning the
wall bracket (2) a minimum 2m above the ground. Ensure the holes are straight by using a spirit level (not
included). Using an impact drill (not included), bore the holes in the positions you have just marked.
2.
Insert 4x universal wall plugs (C) into the drilled holes. Insert 4x screws (B) into the wall plugs leaving heads
outside. Attach the bracket to the heater (1) using 3x screws (A) inserting these into the threaded holes on the
back of unit.
3.
Hang the bracket onto the 4 screws in the wall.
Operation
Before plugging the heater into a power supply, please first adjust the angle of the heater.
You can change the angle of your heater by up to 45⁰. You can adjust this by moving the heater (1) to your desired
angle. Please only change the angle of your heater when it is NOT in use and it is completely cool.
To operate, ensure the heater is plugged into the correct electrical socket outlet.
Pull down the switch cord to turn the unit ON.
Controlling the heat output of the unit please use the dial as indicated in the below diagram.
The unit if OFF when “0” is selected, low power when “1” is selected, medium power “2” is selected and high power
when “3” is selected.
1 (1x)
2 (1x)
