.
32
© Weldclass 2019 | E.&O.E. | Edition 2.2
7.1.7
Adjusting Settings for MIG Welding in Manual Mode (Program 0)
1.
Follow above steps for either ‘Gasless Welding Setup’, ‘Gas MIG Welding Setup’ or ‘Spool Gun
Setup’ (whichever is relevant)
2.
Set welding process selector to ‘MIG’ (refer to 4.1)
3.
Set the MIG Program to ‘0’ (refer to 4.2)
4.
Set the desired Voltage output using the Left Adjustment Knob (31). Voltage setting will show on
Left LCD Readout (39).
5.
Set the desired Wire Speed using the Right Adjustment Knob (32). Wire Speed setting will show
on Right LCD Readout (38) in meters per minute (m/min).
6.
Adjust Inductance if required (refer to 4.5)
7.
Adjust special Function settings if required (refer to 4.3)
7.1.8
Adjusting Settings for MIG Welding in Synergic (Auto) Mode
1.
Follow above steps for either ‘Gasless Welding Setup’ or ‘Gas MIG Welding Setup’ (whichever is
relevant)
2.
Set welding process selector to ‘MIG’ (refer to 4.1)
3.
Set the MIG Program to the relevant Program number (refer to 4.2)
4.
To set output by Amperage: Rotate Right Adjustment Knob (32) to choose amperage
OR
To set output by Material Thickness: Press Right Adjustment Knob (32) in then Rotate Right
Adjustment Knob (32) to choose material thickness
5.
You can use the Left Adjustment Knob (31) to fine tune the voltage if the standard synergic
program does not suit your exact welding application.
6.
Adjust Inductance if required (refer to 4.5)
7.
Adjust special Function settings if required (refer to 4.3)
Summary of Contents for WeldForce WF-255MST
