Page
10
of
11
EXTRAORDINARY MAINTENANCE:
EXTRAORDINARY MAINTENANCE OPERATIONS SHOULD BE CARRIED OUT ONLY AND EXCLUSIVELY BY
SKILLED OR AUTHORISED ELECTRICAL-MECHANICAL TECHNICIANS.
WARNING! BEFORE REMOVING THE WELDING MACHINE PANELS AND WORKING INSIDE THE MACHINE
MAKE SURE THE WELDING MACHINE IS SWITCHED OFF AND DISCONNECTED FROM THE MAIN POWER
SUPPLY OUTLET.
IF CHECKS ARE MADE INSIDE THE WELDING MACHINE WHILE IT IS LIVE, THIS MAY
CAUSE SERIOUS ELECTRIC SHOCK DUE TO DIRECT CONTACT WITH LIVE PARTS AND/OR INJURY DUE TO
DIRECT CONTACT WITH MOVING PARTS.
SECTION 10 : CIRCUIT DIAGRAM
- Inspect the welding machine regularly, with a frequency depending on use and the dustiness of the environment,
and remove the dust deposited on the transformer, reactance and rectifier using a jet of dry compressed air (max. 5
bar).
- Do not direct the jet of compressed air on the electric boards; these can be cleaned with a very soft brush or suitable
solvents.
- At the same time make sure the electrical connections are tight and check the wiring for damage to the insulation.
- At the end of these operations, reassemble the panels of the welding machine and screw the fastenings right down.
- Never carry out welding operations while the welding machine is open.
Weldability MIG160T
