Cordless Quick Start Guide
4
Associating the Cordless Scanner to a Base
Important: Make sure the Cordless Scanner’s battery pack has been fully
charged. See page 3 for charging instructions.
Using the Cordless Scanner, scan the Association Bar Code (the bar code label
on the top of the Base) to link that scanner to the Base (see the illustration below).
Two quick beeps followed by clicking, then a single beep indicates a “good”
association. The scanner is in communication with the Base.
Cordless CCD or
Laser Scanner
Cordless
Base
Association
Bar Code
Note: To set up and connect the Cordless System to the host system, refer to
the Cordless System Manual that is shipped with each Base unit. The System
Manual includes all programming selections, more detailed explanations of the
Cordless System, product specifications, scan maps, connector illustrations and
pinouts, maintenance and troubleshooting information.
After association, if the battery pack is removed from the scanner and replaced,
the scanner automatically re-associates to the base if the base has remained
powered up. In this case, the scanner beeps when a charged battery pack is
installed, then clicks and beeps a second time after full association, about five
to ten seconds later.
Summary of Contents for SCANTEAM 3470 CCD
Page 1: ......
