Welbilt Frymaster FilterQuick 2FQG30U, Service Manual

Page: 19 / 80

1-14
NOTE:
Replacing the burner rails requires completely tearing down the frypot and installing new frypot
insulation. Refer to the frypot exploded view below for component identification.
1. Remove the frypot per Section 1.9.11.
2. Remove the burner assemblies (1).
3. Remove insulation retainers and blanket insulation (2).
4. Remove the upper oil zone insulation bracket and upper oil zone insulation (3).
5. Remove the plenum (4).
6. Remove the front lower combustion chamber insulation retainer and insulation (5), and the front lower
combustion chamber inner insulation retainer and insulation (6).
NOTE:
Full-vat units have two-piece
insulation retainer and insulation components. Dual-vat units have one-piece components.
7. Remove the upper combustion chamber insulation retainer and insulation (7).
8. Remove the inner upper combustion chamber insulation retainer and insulation (8).
9. Remove the rear lower combustion chamber retainers, back, and insulation (9).
NOTE:
Full-vat units have
two-piece backs and four retainers. Dual-vat units have one-piece backs and two retainers.
10. Remove the flue assembly (10).
Disassembling A Frypot
(Full Vat Illustrated)
Spacers
Spacer
10
2
3
4
5
6
7
8
1
11
9
See page 1-16 for reassembly illustration.
11.
Remove the upper burner rails (11).
NOTE:
For the following steps, refer to the frypot exploded view on
page 1-16 for component identification.
12. Remove any residual insulation, sealant, and/or oil from the exterior of the frypot.
13. Place the “L” shaped pieces of the combustion chamber insulation (1) in the front and rear corners of both
upper rail-retaining slots. (See page 1-16).
14. Using a mallet and short piece of wood, tap the corner tabs of the combustion chamber over the insulation
to ensure a solid seal of the burner.
15. Install the upper burner rails (2) with the heat deflectors slanting toward the rear of the frypot. The rails
will cover the “L” shaped pieces of combustion chamber insulation previously installed.