6. Cleaning
Page 56
105204
– WTS-300-E - V4.1 - 20.01.2022
6.5 Abort of the cleaning
6.5.1 Cleaning cycle completely finished
If all rinsing cycles have been completed, this is signalled by the "green LED". De-
pending on the parameterisation [P60], cleaning changes to "OFF mode" or to "cool-
ing mode".
NOTICE: Any errors that occurred during cleaning that did not lead to cleaning being
interrupted are shown on the display.
6.5.2 Manual abort of the cleaning
Cleaning is aborted manually by pressing the OFF key:
-
cleaning stops,
-
the display alternately shows 'AbL' and the current temperature,
-
the drain valve is opened for the time [n100] (can be stopped by pressing the
OFF key again).
-
depending on the parameterisation [P60], cleaning changes to 'OFF mode' or
'cooling mode'.
6.5.3 Abort of the cleaning due to faults
Fault messages are displayed:
- flashing on the display
- via SMS or email (optional)
The following faults cause the abort of the cleaning:
F40
- Tank outlet safety switch activated
F41
- Pressure switch for cleaning line
F42
- Thermal contact for washing pump
F44
- TIMEOUT water intake above level
F45
- Water in tank after emptying
F46
- TIMEOUT water intake quantity controlled
-
cleaning stops,
-
the display alternates between 'AbL' and the fault number,
-
the drain valve is opened for the time [n100],
-
the control unit remains in cleaning mode.
-
Fault code is displayed and must be acknowledged.
NOTICE: The drain time [n100] can be stopped by pressing the OFF button.
See also section 7.5.3
Reset / acknowledge the fault messages:
Press the RESET button for approx. 4 seconds.
RESET
