22
4.5
Assembly of guard bow
Arrange the plastic washers (1) between the bore on the gearbox housing
and the inside of the guard bow.
Guide the bracket axle (2) through the hole and secure the bracket axle
with the washer (3) and the locking washer (4).
Insert the locking washer by hand into the corresponding groove in the
bracket axis.
4.6
Assembly of guide plate
Mount the guide blade [6] into the corresponding holes on the gear box
housing using the enclosed hexagon socket head screws (1).
The guide blade serves to stabilize the saw blade during the sawing process
and to distribute the water.
Make sure that the rubber grommet (2) on the gearbox housing matches the
opening for the water supply in the guide blade.
The guide plate must be installed in such a way that the
grommet (2) on the transmission housing matches the bore for
the water supply in the guide blade. If the guide blade is not
properly mounted, the saw blade can be insufficiently supplied with water. If the saw blade
is not cooled, personal injury and property damage may occur.
4.7
Assembly of drive wheel
Insert the drive wheel [20] onto the driving spindle of the ring saw. Make sure that the inner contour of
the recess on the drive wheel matches the outer contour on the spindle.
Secure the drive wheel by screwing the hexagon head screw [19] counterclockwise. Tighten the hexagon
head screw firmly, using the combination spanner and face spanner (see scope of delivery).
Hexagon head screw is provided with a left-hand thread!
4.8
Assembly of saw blade
Check the saw blade for damage before installation. Damaged saw blades can lead to
personal injury.
If the saw blade is worn out (diamond segments worn out), the saw blade must be
replaced. It is not permitted to provide the used saw blade with new diamond segments
(new tipping). If the used saw blade is equipped with new segments, personal injury and
property damage may result.
Handle saw blades with care. If individual segments are missing, or if the blade is poorly
tensioned, if it has a concentricity error or stroke, dangerous unbalances can occur which
could damage the saw and endanger the operator. Our sales partners are specialists for
these tools. Please have a thorough consultation before choosing a saw blade.
Loosen the adjusting knobs [10] so that the spring tension is completely loosened.
Unscrew the hexagon head screw [14] and turn the T-handle [15] clockwise as far as it will go (away from
the saw).
Assemble saw blade
The saw blade has two grooves (1) on one side. These grooves form the guide for the guide rollers.
Mount the saw blade so that the V-shaped edge engages the drive wheel [19] and the two embossments
of the guide roller (2) fit into the grooves of the saw blade.
If necessary, the position of the guide rollers can be adjusted by turning the adjusting knobs [10].
Turn the T-knob so that the support rollers [17] get light contact with the saw blade. The support rollers
1
2
3
4
1
2
Summary of Contents for TR40 ANNA
Page 3: ...11 12 13 14 15 16 1 2 3 4 5 6 9 8 7 10 ...
Page 4: ...19 20 21 21 17 18 18 ...
Page 5: ...1 ...
