© COPYRIGHT Weiss Ltd 2019. All rights reserved
Weiss Limited reserves the right to alter designs and specifications
without notice and without obligation
ER12C-3
Revision 02.0 140319
•
The controller will turn off after 5 seconds of no activity in programming mode
COMPLIANCE AND WARRANTY INFORMATION
•
This appliance must be installed by a registered electrician in accordance with the relevant electrical
wiring rules and regulations and a COC is required for a warranty claim.
•
Not for use with a heat pump
•
Do not cover the fan unit with any insulation material
•
Do not completely close off adjustable outlet vents
•
Always install this product with the supplied controller
•
Weiss Limited reserves the right to alter designs and specifications without notice
•
Incorrect wiring or installation is not covered by warranty
•
Full Warranty information is available on our web site: https://www.weiss.co.nz/warranty
QUESTIONS AND ANSWERS
Can I place the controller in a different room from the fireplace/heat source?
No. The controller must be mounted in the same room as your heat source. Make sure that the controller is
in a position where it can easily detect changes in the room temperature from your heat source, e.g. 2-4
metres away from the heat source. Do not place the controller in the hallway or near the doorway, around
a corner from the heat source, or far away (>6 metres) from the heat source in a large room.
How far away from the heat source should I place the fan?
You should keep at least 1.5 metres of distance between the heat source extraction point and the fan.
However, the recommended distance between the extraction point and the fan is 3 metres.
IMPORTANT NOTES
Technical Specifications
Set Temperature Range:
5 - 35°C
Temperature Resolution:
0.5°C
Operating Voltage/Frequency:
230VAC 50Hz
Sensing Element:
NTC thermistor
Operating Temperature:
0 to 40ºC
Operating Humidity:
5 - 90% non-condensing
Output Control:
Digital control interface
Display:
3.5” digital LCD Touchscreen
Approval:
All relevant AS/NZS standards
EMC Approval:
All relevant AS/NZS standards
•
The unit should be checked annually for correct operation.
•
This controller has been designed to work with Weiss Heat Transfer AC Fans only.
Weiss Limited, 20b Arwen Place, East Tamaki
PO Box 204-120 Highbrook Auckland
New Zealand
Web:
Advanced set-up screens
1.
Temperature calibration: adjust with the Adjust Up and Down
buttons
2.
Maximum operating temperature (not used): default value 25°C
3.
Minimum operating temperature (not used): default value 20°C
