KNX IP LineMaster 760
WEINZIERL ENGINEERING GmbH
EN
2014-07-01
Page 5/6
Operation (Settings at the device)
Basic settings of the display
KNX LineMaster
IP Router & Power S.
Normal Operation
Diagnostics >
The following may be read off and set on the display
of the KNX Linemaster:
•
Reset of a line
•
Recall of the data memory with operating hours,
overcharge, external electrical surge, internal elec-
trical surge, short circuit and excess temperature
•
Recall of the operating data bus voltage, bus cur-
rent and temperature
•
Language of display
The background lighting of the display will switch off
automaticly if the temperature in the housing exceeds
50°C. This avoids an excessive thermal stress of the
device.
Line Reset
Basic setting
KNX LineMaster
IP Router & Power S.
Normal Operation
Diagnostics >
The section „Diagnostics“ will be shown when the
button is pressed once.
Line Reset
> #
Data Memory
>
Operating Data >
Languague
>
The section „Line Reset“ will be shown when the
but-
ton is pressed twice.
Reset: Yes #
No
30 seconds
Reset not active!
The cursur (flashing rectangle at right edge) can be
moved to the desired setting with the buttons
or
. It
can be confirmed with
button.
Yes:
Reset is activated. The line is
switched to neutral and short-
ed. The basic setting displays:
“Reset is active!”
No:
Reset not activated. The pow-
er supply system works in
normal operation.
30 seconds:
A reset of 30 seconds is start-
ed. Afterwards, the line is sup-
plied with voltage as usual.
During the reset state, which
lasts 30 seconds, the basic
setting displays: “Reset active:
XX sec” (countdown).
The
button returns to the previous menu level.
Data memory
Basic setting
KNX LineMaster
IP Router & Power S.
Normal Operation
Diagnostics >
The section „Diagnostics“ will be shown when the
button is pressed once.
Line Reset
>
Data Memory
>#
Operating Data >
Language
>
Move the cursor (flashing rectangle at right edge) to the
“Data memory” menu with the buttons
and
and and
confirm with key
.
Hours ofOperation >#
Overload >
Ext. Overvoltage >
Int. Overvoltage >
Short circuit >
Excess Temperat. >
The cursur (flashing rectangle at right edge) can be
moved to the desired setting with the buttons
and
. .
It can be confirmed with
button.
Operating hours
Run time: 0 years
0 day 0 hrs.
<= Back
The operating hours of the power supply system are
displayed in years, days and hours.
The
button returns to the previous menu level.
Overload
Overload detected
0 times. Duration:
0 day. 0 hrs. 0 min
<= Back
The number of overload incidents and the total time in
days, hours and minutes are displayed.
The
button returns to the previous menu level.
External Overvoltage
External Overvoltage
was detected
0 times.
<= Back
The number of external overvoltage incidents is dis-
played.
The
button returns to the previous menu level.
