Operating Instructions
Power Setting (for
Lux
and
Tempura
)
A power setting is an arbitrary brightness
or heating setting. After programming,
this can be activated by pressing the
or
button twice. Power settings can be
reprogrammed at any time.
How to programme the power setting
1. Set the level to maximum or minimum.
2. Hold down the
or
button for as
long as it takes to reach the desired
setting.
3. As soon as the desired setting is
reached, press the
button as well.
4. The setting will stop and the power set-
ting is programmed.
Cleaning
• Only ever clean the device using a dry
cloth.
• Never use any detergents as these can
damage the plastic.
Declaration of Conformity
weinor hereby certifies that the weinor
Remoto 1M handheld remote control is in
compliance with the material require-
ments and all other relevant provisions of
the Guideline R&TTE 1999/5/EC.
Area of Application
This device has been certified for use in
Switzerland and within the European
Union.
Using a suitable screwdriver, open the
back of the handheld remote control.
Remove the old battery and insert the new
battery (coin cell 2430) making sure that
the symbols match (“+” can be seen at the
top). Dispose of the old battery in an envi-
ronmentally-friendly manner.
Replace the back plate and screw it down
onto the handheld remote control using a
screwdriver.
Changing the Battery
Troubleshooting
Error
Cause
Remedy
• The drive isn’t running; the trans-
• The battery is low or
• Insert a new battery
mission check display doesn’t flash
has been inserted
or the same battery
when a button is pressed.
in the wrong way.
in the correct manner.
• The drive is running; the trans-
• The battery is low.
• Insert a new battery.
mission check display does not
run when a button is pressed.
• The drive isn’t running; the
• The receiver is outside • Reduce the distance
transmission check display flashes
the frequency range.
to the receiver.
when a button is pressed.
• The desired drive isn’t
• No mains supply
• Connect the mains
running.
(230 V).
(230 V).
• The circuit breaker
• Switch on the circuit
has been triggered.
breaker.
㛯㛯㛯
㛯㛯㛯
weinor GmbH & Co. KG
Mathias-Brüggen Straße 110
50829 Cologne
Hotline: +49(0)221/5 97 09-214
Fax: +49(0)221/5 97 09-898
Subject to change without notice
www.weinor.com
Should you have any further queries, please contact your weinor specialist.
Translation of original instruction manual
