BiConnect BiRec MVLED/MLED
Version 4
2020-07-08
Assembly and installation instructions/ Instructions de montage et d’installation
Item number/
We reserve the right to make technical changes/ Sous reserve de modifications techniques Numéro d’article 116692-0000 Page 10/28
5.3 Programming the light
1. The light alternates between 100% and 50% power.
2. Press the learning key on the hand transmitter for 2 seconds. This step does not apply to the
unidirectional hand transmitter (Remoto). The light is currently in learning mode.
3. On the hand transmitter, select the channel you want to use to program the lighting (e.g.
Channel 2).
4. Within the first second during which the lighting brightens to 100% power, briefly press the
UP key. The receiver confirms this command by briefly switching off and then on.
5. Then, within the first second during which the lighting dims to 50% power, briefly press the
DOWN key. The receiver confirms this programming by briefly switching off.
Initialise any other transmitters or sensors that are being used.
Finally, check that the awning and lighting have been successfully programmed.
5.4 Programming other transmitters on a receiver
1. Select the appropriate channel on a transmitter already programmed on this receiver.
2. Start the programming mode. Press the UP key, DOWN key and LEARN key for at least 6
seconds until the status indicator lights up briefly.
3. Briefly press LEARN key on the transmitter to be programmed until the status indicator lights
up briefly.
4. Now proceed as in 5.2 for drivers or 5.3 for lights.
5.5 Deleting all transmitters on the receiver
1. Select any of the receiver's channels (main drive, light or valance) on a transmitter
programmed on this receiver.
2. Press the UP key, DOWN key, STOP key and LEARN key for at least 5 seconds. The status
indicator lights up twice briefly orange-green and then red.
