Part Number 550-141-186/0100
15
• Installation • Start-Up • Maintenance • Parts
Flue collector hood
See
Figure 13
— single base shown.
Refer to the
table below
, for proper arrangement.
1. Assemble bolt, washer and nut to section joint.
2. Apply retort cement for gas-tight seal.
Figure 13
Flue collector hood assembly and sealing the boiler
Gas-tight seal
2e
Boiler assembly
flue collector hood
Hood must be sealed gas-tight to prevent possibility of flue gas spillage
and carbon monoxide emissions, causing severe personal injury or death.
3. Mount hood on section assembly. Fasten with washers and nuts.
Apply retort cement between bottom of sections and top of base assembly. See
Figure 13
.
Sealing the
boiler
Boiler must be sealed gas-tight to prevent possibility of flue gas spillage
and carbon monoxide emissions, causing severe personal injury or death.
Washer
Washer
Flue collector hood
Retort cement
Retort cement
186-13
Right end
section
Right end
of base
Carriage bolt
Carriage bolt
Nut
Nut
Boiler Model
Number
Flue Collector Hood(s)
(from left side of boiler)
LGB-4
4
--
LGB-5
5
--
LGB-6
A
--
LGB-7
B
--
LGB-8
C
--
LGB-9
D
--
LGB-10
E
--
LGB-11
F
--
LGB-12
G
--
LGB-13
B
B
LGB-14
C
B
LGB-15
C
C
LGB-16
D
C
LGB-17
D
D
LGB-18
E
D
LGB-19
E
E
LGB-20
F
E
LGB-21
F
F
LGB-22
G
F
LGB-23
G
G
