Specialized Concentrated Focused
「
46
」
Menu Functions
CAUTION
“Finish Times”, i.e. processed times, is shown in real time. After “Circle Times”
is finished, “Finish Times” restores to 0 automatically.
[Configs]
In 52C configuration, there are two configurations, including
―Auto-H‖ and ―Cylinder‖; In 63A/62A
software, there are three configurations, including
―1Y (6A+EX22A)‖, ―2Y (6A+EX22A)‖, ―Yrev
(6A+EX22A)
‖. For the wiring diagram of terminal board in each configuration, refer to Chapter 7.2.
Modification to configuration becomes valid after restart.
[Go Home (Ctrl + Home)]
Machine coordinate system is the inherent coordinate system of a machine tool. Its origin, also known
as machine origin, reference point, and home, is fixed after design, manufacture and debugging before
leaving factory. After this software is booted, generally it is necessary to home all axes manually or
automatically.
CAUTION
The necessity of homing:
Only after homing can the following functions be enabled, like software limit and
set fixed point.
―Go Home‖ can be divided into ―All Go Home‖, ―X Go Home‖ and ―Y Go Home‖. After one of them is
selected, a dialog as shown in Fig. 4-37 will pop up to prompt confirmation for homing.
Fig. 4-37 Prompt box for homing
After homing is performed, the homing mark
―
‖ after ―Axes‖ indicates that homing has already been
successfully completed.
If the accuracy of current machine coordinates is ensured, and no abnormal conditions like
―E-stop‖
occur, clicking
―Set Directly‖ can set current machine coordinates as correct and accurate. When this
operation completed, the homing mark
―
‖ appears after ―Axes‖.
When
―Go Home Setting‖ is selected, a dialog as shown in Fig. 4-38 will pop up. If ―This dialog pops up
automatically when the software is started
‖ is checked, this dialog will pop up automatically each time
the software is opened. Otherwise, it needs to be manually opened.
