10
Low battery
“Lo” is displayed when the batteries need to be replaced. Open the
battery door on the back of the scale, and remove and replace the
batteries with four AAA batteries.
Overload
Overload occurs when the scale has too much weight (Capacity:
180kg / 397lb). Please remove the weight on the scale to protect
the scale sensors.
Measuring error
If the scale has trouble measuring your weight, it will show “Err”
and turn off. This is most likely due to not settling on the scale fast
enough. Make sure that the scale is placed on a flat hard surface
(not carpet), and you distribute your weight evenly while holding
still.
Failed to auto-detect your user profile while weighing
The weight data is shown only and the scale will turn off after a few
seconds. Please manually select your number and measure once
again (Press-Awake, select user number, Tap SEL).
Resolving an auto-detection conflict
An auto-detection conflict will occur if two or more users are within
10lbs. of each other. When an auto-detection conflict occurs, your
scale will give you a chance to select your profile number manually.
Use the arrows to select your profile, tap SEL, and step on the scale.
The scale will now proceed measuring for the profile you have
selected.
How do I clear a user profile?
First, Press-Awake the scale on, then press and hold SEL. Now,
select the user to delete and press SEL. Once selected, press the up
arrow to change Clr to “Y.” Now press SEL to clear the user. The user
is now removed.
Troubleshooting
Summary of Contents for Weightless Series
Page 15: ...14...
