ARM ASSEMBL
Y
8.
Wet the handle of one Press Arm (46) with
soapy water. Slide a Hand Grip (31) onto the
handle. Press a 1” Round Inner Cap (49) into
the other end of the handle. Press a 1 3/4”
Square Inner Cap (44) into the Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16” x 2 1/2”
Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
9.
Identify the Right Arm (48) and the Left Arm
(47). Note the position of the welded
bracket on each Arm. Arm identification is
very important for step 10.
Attach a “V”-Pulley (6) and a Long Cable Trap
(50) to the Right Arm (48) with a 3/8” x 2 1/2”
Bolt (7) and a 3/8” Nylon Locknut (21).
Attach a “V”-Pulley (6) and a Long Cable Trap
(50) to the Left Arm (47) in the same manner.
10. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); refer to step 9
to identify the Right Arm. Be sure that the
upper end of the Right Arm is behind the
indicated bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round
Cover Cap (70) onto the right axle. Be sure
that the teeth on the Retainers bend
toward the Cover Cap, as shown in the
inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the
lower ends of the Right and Left Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10” Pad (45) onto the
lower end of each Arm.
8
8
44
31
3
22
17
47
6
50
7
50
6
Welded
Brackets
21
69
70
45
44
48
47
48
44
49
46
46
49
9
10
45
Lubricate Axle
Bracket
69
70
55
55
