Weider 9300 PRO, User Manual

Page: 11 / 33

11
17. Press a 1 3/4Ó Square Inner Cap (48) into the
lower end of the Left Fly Arm (6). Wet the
lower end of the Left Fly Arm with soapy
water. Slide a 10Ó Pad (22) onto the Left Arm.
Repeat this step with the Right Fly Arm (5).
18. Locate and open the parts bags labeled
ÒCABLE ASSEMBLYÓ and ÒPULLEYS.Ó
During steps 19 through 45, refer to the
CABLE DIAGRAMS on pages 25 and 26 of
this manual to verify proper cable routing.
Before beginning this section, fully unwind the
five Cables and identify the Cables by com-
paring the lengths and the ends. The approxi-
mate length of each Cable, in inches, is listed
after the key number in the drawing.
IMPORTANT: While assembling the cables,
do not over tighten the bolts and nuts
attaching the pulleys. The pulleys must be
able to turn freely.
19. Insert a 5/16Ó x 1Ó Bolt (51) through the brack-
et on the Right Fly Arm (5). Tighten a 5/16Ó
Nylon Jam Nut (90) onto the Bolt.
Identify the Butterfly Cable (88)Ñthis is the
second shortest Cable.
Slide one end of the
Butterfly Cable onto the 5/16Ó x 1Ó Bolt (51).
Thread another 5/16Ó Nylon Jam Nut (90)
onto the Bolt,
but do not fully tighten it.
Leave enough room between the two Jam
Nuts for the Cable to pivot.
19
17
18
CABLE ASSEMBL
Y
ARM ASSEMBL
Y
5
6
48
22
87Ñ212 1/2Ó
51
5
90
88
22
85Ñ110Ó
84Ñ99 5/8Ó
88Ñ82 3/16Ó
86Ñ71 1/2Ó