32.
Identify the Ab Cable (74).
It is approximately
226 1/2” long, and it has a ball on one end and
an eyelet on the other.
Wrap the Ab Cable (74) around a 3 1/2” Pulley
(35) as shown. Place two Pulley Covers (39) over
the Pulley, so that the large tabs are on the side
shown. Attach the Pulley and Pulley Covers to the
Butterfly Upright (4) with a 3/8” x 3 3/4” Bolt
(101), two 3/8” Washers (97), and a 3/8” Nylon
Jamnut (92).
Make sure the Cable is between
the Pulley and the pin on the Upright.
32
92
97
Pin
74
97
101
39
39
Large tabs
on this side
4
35
29. Remove the 3 1/2” Pulleys (35) from a pair of pre-
assembled Pulley Plates (32).
Wrap the Rear Cable (70) around a 3 1/2” Pulley
(35) in the direction shown. Attach the Pulley and
a Cable Trap (38) to the top hole in the pair of
Pulley Plates (32) with a 3/8” x 2” Bolt (93) and a
3/8” Nylon Locknut (90).
Make sure the Cable
Trap is positioned to hold the Cable in the
groove of the Pulley.
29
15
30. Wrap the Rear Cable (70) around a 4 1/2” Pulley
(36) in the direction shown. Attach the Pulley
inside the indicated bracket on the Center Top
Frame (8) with a 3/8” x 1 3/4” Bolt (94) and a 3/8”
Nylon Locknut (90).
70
93
38
90
31. Attach the end of the Rear Cable (70) to a “U”-
Bracket (33) with a 1/4” Washer (99) and a 1/4”
Nylon Locknut (103).
Attach the “U”-Bracket (33) to the Short Weight
Tube (44) with a 5/16” x 1 3/4” Bolt (96) and a
5/16” Nylon Locknut (86).
32
32
35
31
30
70
86
33
103
96
44
99
36
90
Bracket
8
94
70