7. Attach the Backrest Tubes (5) to the Backrest (6)
with four M6 x 38mm Screws (30) and four M6
Washers (26). Do not tighten the Screws yet.
8. Insert the Support Rod (7) through a set of holes
in the Uprights (1). Rotate the Support Rod to the
locked position, with the locking pin wrapped
around the Upright.
Lubricate the M10 x 137mm Bolt (36) with
grease. Attach the Backrest Tubes (5) to the
welded tube on the Frame (2) with the Bolt, two
M10 Washers (34), and an M10 Nylon Locknut
(33). Do not overtighten the Locknuts; the
Backrest Tubes must be able to pivot easily.
Tighten the M6 x 38mm Screws (30) used in
step 7.
9. Attach the Seat (11) to the Frame (2) with four M6
x 16mm Screws (29).
7
7
5
30
26
26
30
6
8
Lubricate
34
5
36
7
1
2
Welded
Tube
1
Locking
Pin
33
34
9
11
29
2
10. Slide a Weight Stop (28) onto the weight tube on
a Fly Arm (25).
Assemble the other Fly Arm (not shown) in
the same manner.
10
28
Weight
Tube
25
