Weh TW241, Operating Instructions Manual

Page: 17 / 80

7�2 Installing the media line for body size 1 to 3
Please note: Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 10 .
Î Unscrew the protection cap from the port.
Î
When mounting media hose line, hold an open-ended
spanner against the spanner flat AF(1) ( Figure 1 ).
Î Screw the ‘B1’ media inlet pressure-tight to the port for the
media line ( Figure 1 ).
For the tightening torque, please refer to the table below.
Ports Torque
1/8" female thread 10 Nm ± 2 Nm
1/4" female thread 30 Nm ± 2 Nm
3/4" female thread 60 Nm ± 2 Nm
Î
Please note the connection size marked on your product.
- Other connection sizes are available on request.
7�3 Installing the media line for body size 4 to 7
Please note: Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 10 .
Î Unscrew the protection cap from the port.
Î
Clamp the WEH
®
Connector in a vice with aluminium
clamping jaws to mount the media line.
Note: The WEH
®
Connector must not be damaged during
clamping.
Î
Screw the ‘B1’ media inlet pressure-tight to the port for the
media line ( Figure 2 ).
For the tightening torque, please refer to the table above.
Figure 1
A/F(1) B1
Figure 2
B1
MD-10026-L51-R1.0.0-03
Page 17
Operating instructions AE