7�2
Installing the filter
Please note:
Subsequent mentions of descriptions and position numbers refer to
Chapter 3. Product overview / product description on page 11
Î
Unscrew the protection caps from the ports.
Î
Use an open-end wrench to hold the wrench size in place when installing the
WEH
®
Product.
Î
Screw the media inlet ‘B1’ of the filter housing pressure-tight to the media inlet.
For the tightening torque, please refer to the table below.
Attention:
Please note the flow direction marked on the product.
Note:
For tube fittings, please note the WEH
®
Operating instructions "Products with
double ferrule fitting".
Î
Screw the media outlet ‘B2’ of the filter housing pressure-tight to the media outlet.
For the tightening torque, please refer to the table below.
Attention:
Please note the flow direction marked on the product.
Note:
For tube fittings, please note the WEH
®
Operating instructions "Products with
double ferrule fitting".
Ports
Torque
B1:
G1/2“ female thread
50 Nm +10%
B2:
G1/2" male thread
50 Nm +10%
Î
Please note the connection size marked on your product.
- Other connection sizes are available on request.
- Optionally, the T-Filter can be attached at any position via the 4 bores. To do this,
fasten the T-Filter according to the hole pattern (
).
Figure 3
55
30
M6x1
14 mm tief
Figure 4
60
60
M8
25mm tief
MD-10211-L51-R1.1.0-03
Page 18
Operating instructions
AE
