Q
UICK
S
TART
G
UIDE
2
622 QSG-800067-02 Rev. B.fm
www.wegener.com
Desktop Installation and Circuit Protection Requirements
To set up the
iPump 622
in a desktop environment, place the unit on a flat surface where it will not
be subject to spills or impacts. Route cables to the unit so that they will not be hit or pulled, causing
damage to the connectors or to the unit itself. Ensure that there is a sufficient flow of cool air
around the unit so that its operating ambient temperature range is not exceeded.
When connecting the
iPump 622
unit to the power supply, review the ratings of all equipment in the
circuit to ensure that the branch circuit, as well as the power source, will not be overloaded. Also
make sure that a protected power strip is used to attach it to the power supply.
System Setup
This figure illustrates the basic system setup for an
iPump 622
:
WARNING:
FCC-Mandated Suppression of Radio Frequency Emissions
This is a
Class A
product. In a domestic environment this product may cause radio
interference for which the user may need to take mitigating action. If the Ethernet port
has a cable connected to it, that cable must be properly shielded and grounded to
minimize RF emissions that could interfere with nearby equipment.
