WEG Drive Scan, Manual

Page: 55 / 74

6
SETTING THE DRIVE SCAN ON THE MFM
Step 15 If successful, proceed to Step 16 . If an error message pops up ( Figure 6.17 ), check its content
and click on:
“Back”: return to Step 11 .
If the error persists:
return to the configuration tab;
use the Factory Reset option (
Figure 6.18 );
return to Step 1 , it is necessary to redo all the settings.
Figure 6.17: Failed to unlink the Drive Scan from the MFM
Figure 6.18: Command to reset the Drive Scan to factory default
Low Voltage Devices | 6-10