WEG Drive Scan, Manual

Page: 49 / 74

6
SETTING THE DRIVE SCAN ON THE MFM
Step 6 Make the settings for the connection to the Wi-Fi internet network, as shown in Figure 6.6 :
SSID (Service Set Identifier): Wi-Fi network name;
Default Route: enable/disable the use of the default network route for the destination address
of IP packets;
Security: defines the Wi-Fi network access protection mode to be used:
– – Open network
– WPA2-PSK
– WPA2-Enterprise
– WEP
EAP Type: defines the network authentication framework to be used:
– None
– PEAP-MSCHAPV2
– PSK
– PEAP
– TTLS-MSCHAPV2
Identity: username to authenticate to the Wi-Fi network
Password: password or pin to authenticate to the Wi-Fi network
Figure 6.6: Wi-Fi network internet configuration
Go to the bottom of the page and click on the “Save Configuration” button ( Figure 6.7 ).
Go to Step 7 .
If the connection is via ethernet port GbE0 ( Figure 6.1 ) e avance ao Step 17 .
Figure 6.7: “Save Configuration” button
Low Voltage Devices | 6-4