WEG CFW501 V1.8X, Programming Manual, Page: 70 / 192

Logical Command and Speed Reference
7-12 | CFW501
7
P0682 – Serial / USB Control
Adjustable
Range:
0000h to FFFFh Factory
Setting:
Properties:
ro
Access groups
via HMI:
NET
Description:
The inverter control word for a certain source is accessible for reading and writing, but read only access is
permitted for the other sources. The inverter has a common word for interface, which is defined by the function
of its bits separately as per
Table 7.5: Control word (P0682) on page 7-12 .
Table 7.5: Control word (P0682)
BIT Function Description
0 Enable Ramp
0: Stops the motor by deceleration ramp.
1: Turn the motor according to the acceleration ramp until reaching the speed reference value.
1 Enable General
0: Disable the inverter completely, interrupting the power supply to the motor.
1: Enable completely the inverter, allowing the operation of the motor.
2 Run Clockwise
0:
Run the motor in the opposite direction of the reference signal (counter clockwise).
1: Run the motor in direction of the reference signal (clockwise).
3 JOG Enable
0:
Disable JOG function.
1: Enable JOG function.
4 Remote
0: Inverter goes into local mode.
1: Inverter goes into remote mode.
5 2
nd
Ramp
0: Acceleration and deceleration ramp by P0100 and P0101.
1: Acceleration and deceleration ramp by P0102 and P0103.
6 Quick Stop
0: It does not execute the fast stop command.
1:
It executes the fast stop command.
7 Fault Reset
0: No function.
1:
If in fault state, reset the fault.
8 to 12 Reserved
13
Internal PID
Controller
0:
Automatic.
1: Manual.
14
External PID
Controller
0: Automatic.
1: Manual.
15 Reserved