WEG CFW300 V1.3X, Programming Manual

Page: 128 / 157

Reading Parameters
15-2 | CFW300
15
P006 - Inverter Status
Adjustable
Range:
According to Table 15.1 on page 15-2 Factory
Setting:
Properties:
ro
Description:
It indicates one of the possible inverter status. The following table contains the description of each state, as well
as the indication on the HMI.
Table 15.1: Inverter status- P006
P006 Status HMI Description
0 Ready Indicates the inverter is ready to be enabled
1 Run Indicates the inverter is enabled
2 Sub
Indicates the voltage in the inverter is too low for operation
(undervoltage), and will not accept the enabling command
3 Fault
Indicates the inverter is in the fault status. The fault code
will flash
4 Self-tuning Indicates the inverter is executing the Self-Tuning routine
5 Configuration
Indicates the inverter has incompatible parameter
programming. After pressing the key
, it will keep
showing an arrow until the incorrect setting is corrected, as
shown in the figure. Refer to
Section 5.3 SITUATIONS FOR
CONFIG STATUS on page 5-5
7 Reserved
-
-
8 Fire Mode
Indicates that the inverter is in Fire Mode. After pressing
the
key, letter "A" will continue to flash indicating the
state. See Section 9.3 ENERGY SAVING on page 9-7
P007 - Output Voltage
Adjustable
Range:
0 to 240 V
Factory
Setting:
Properties: ro
Description:
It indicates the line voltage in inverter output, in Volts (V).