weewell WHC 750, User Manual

Page: 4 / 20

I
WHC 750 USER MANUAL
4
2) If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
3) Do not add detergents, chemical solutions into the unit.
4) Unplug appliance during filling, cleaning and maintenance.
5) If there is any abnormal smell during normal operation, please switch off and disconnect power supply and contact
with service agent.
6) Never touch water in the Water Basin & components in the water when the unit is in working.
7) Never switch on when there is no water in the water basin.
8) Never scrape Transducer.
9) Never clean Transducer with hazardous detergents, chemical solutions.
10) Never let water splash into inner Base Unit for avoiding components damage.
11) Be careful when using the appliance for emission of hot water vapor.
12) Before cleaning and maintenance, the appliance must be disconnected from the supply main.
13) This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning
use of the appliance by a person responsible for their safety.
14) Children should be supervised to ensure that they do not play with the appliance.
15) Indoor use only.
16) Prior to cleaning or other maintenance, the appliance must be disconnected from the supply mains.
Operation Instruction
Before the first operation, put unit under the room temperature for half of an hour before operate.
It is recommended to use the unit under temperature of 20°C, in relative humidity less than 80%RH.
Use only clear water not over 40°C.
Check the water basin, make sure it is clear.
OPERATING INSTRUCTIONS
1. Put the machine on a flat surface.
2. Fill the water into the water tank, and then tighten the tank cover.
3. Put the water tank on the main body.
4. Check if the rated voltage meets the input voltage, and plug in the socket.
5. Switch on the machine; the background light of LED will be on. The machine begins to work.
6. Touch the symbol “MAX-MIN”, you may adjust the mist volume. On the remote control, just press the button of
“MIST VOLUME”.
7. Touch the symbol “OZONE”, the ozone generator works. On the LED display, it shows the shape of trees. Touch again
to stop the function.
8. Touch the symbol “HEATING”, the warm mist will come out after 10 minutes. On the LED display, it shows the shape
of fire. Touch again to stop the function. Mist will become cool.
9. Constant humidity: Before you touch the symbol “HUMIDITY”, LED display shows the current humidity. You may set
the humidity arranged from 45%RH to 90%RH. Press once, it will increase by 5%RH. When it reaches 90%RH, press
again, it will back to 45%RH. After you set the expected humidity, the machine will keep the memory after 5 seconds.
5 seconds later, LED display shows the current humidity. If the expected humidity is less than the current humidity,
the machine will be in sleeping state. But if the expected humidity is higher than the current humidity, the humidify
function will work.
10. Timer setting: There are 12 timer setting: 1,2,3,4,5,6,7,8,9,10,11,12 hours. Touch the symbol “TIMER”, LED display
shows the timer. The timer shows the rest operation time and decrease by 1 hours, i.e., if set the timer at 12 hours,
LED display shows 11 after one hour. Once you have set the timer, the value of time remaining in timer and the room
temperature will display 30 seconds alternating in the middle of LED display.
11. Once the water in the basin is too little to keep the machine working, the machine will automatically stop
working. LED shows the shape of lack of water. Refill the water, and the machine will restart.