WEM500 USER MANUAL
I
5
20
100
25
2
39
20
150
65
3
39
20
200
45
3
39
20
250
85
4
39
28
50
100
2
39
28
100
60
2
39
28
150
110
3
39
28
200
100
3
39
28
250
105
3
39
*All measures are given approximately
Remember the ideal feeding temperature is just 37˚C (same as breast milk)
ALWAYS check the temperature of the baby milk and food before feeding
your baby.
Getting started
1. Before use, ensure that the warmer and accessories (including mains cable) do not have
any visible damage.
2. Place the holder into the device.
Operation
1. Add required amount of water according to table above into the bottle warmer.
2. Place the baby bottle or jar into bottle rack.
3. Plug the power cord into your socket at home and make sure the wall switch is turned on,
press and button, it may be set from 1 to 12 minutes.
4. The heating cycle is complete when the heating stops and warmer bleeps.
5. Remove the bottle or jar from the bottle warmer, always check the temperature of the
food yourself before feeding to your baby.
6. Unplug the bottle warmer from the mains supply and leave to cool down before cleaning.
Care of your bottle warmer
•
The bottle warmer must never be immersed in water, after unplugging form the electricity
supply and allowing to cool down the bottle warmer can be wiped clean and dried with a
clean non abrasive cloth.
•
Lime residues found on the heater plate are quite normal and the severity will depend on
where you live and the hardness of your local tap water, these residues may be periodi-
cally removed by using a dilute solution of 1 part vinegar to 2 parts water, pour into the
heater tray and leave for an hour, rinse off and clean before reusing to heat bottles.
İ
Safety notes
•
This warmer is only to be used by audits and keep out of reach of children.
•
Do not leave cables trailing on a worktop where they can be grabbed by children.
•
Always use on a flat safe and heat resistant worktop.
•
Never immerse the bottle warmer in water.
•
Never use lower than 20 ml of tap water in the bottle warmer.
•
When in use the bottle warmer will contain hot water.
•
Always unplug the warmer from the electricity supply when not in use.
•
Never warm baby foods more than once, discard any food or milk that is not eaten.
•
Always check baby food before commencing feeding to baby.
•
Stir or shake well to ensure an even distribution throughout the foods.
•
If the supply cord is damaged, it must be replaced by the manufacturer or a similarly
qualified person to avoid hazards
•
This appliance is not intended for use by persons (including children) with reduced physi-
cal, sensor your mental capabilities, or lack of experience and knowledge, unless they
have been given supervision or instruction.
•
The device is intended for use in the domestic /private environment only, not in commer-
cial situations.
Please retain these Instructions for yours or others future reference:
Please remember the ideal feeding temperature of baby milk and food s 37 ˚C. When tes-
ting the food temperature it should be neither warm nor cold it should be neutral to the
touch. Test milk by shaking a few drops on the back of your wrist and food by tasting.
Technical Specification
Bottle Warmer
Power Consumption
400w
Operating Voltage
220-240VAC 50/60Hz