Weekender eHawkEye, Operation Manual

Page: 5 / 8

5
Step 2: Attaching Control Linkages
Slide the control linkages through the middle hole in the control horns and then slide the locks over the
end of the linkage as shown above.
Step 2
Step 3: Main Wing Assembly
Slide the wing through the fuselage until prop-
erly positioned.
Step 3
While not necessary, you can apply
a small amount of CA glue to hold
the pieces permanently in place.
Step 4: Receiver Installation
Using the double sided tape, install the receiver
into the fuselage and plug the servo and ESC
leads into the appropriate channels.
Step 4: Battery Installation
Using the included Velcro strip, install the battery
into the front of the fuselage.
Step 4
Step 5
Step 5: Cutting the Control Surfaces
Before flying, you will need to cut the control
surface so they can move freely. Using a sharp
razor knife, cut only where indicated with
dashed lines in the above illustration.
Step 6