9
S
Charge continuously when not in use. Con-
tinuous charging will not damage the bat-
tery. The charger will automatically keep
the battery charged and ready for use dur-
ing storage.
S
During charging, the charger becomes
warm. This is normal and means the char-
ger is operating correctly.
TO CHARGE YOUR UNIT:
1. Place the trimmer in the wall bracket.
2. Plug the charger into a standard house-
hold electrical outlet.
3. When properly connected, the red charge
indicator light (LED) will glow.
NOTE:
The red charge indicator light
(LED) on the charger glows continuously
during charging.
4. The battery will be fully charged in 24
hours.
RECHARGING YOUR UNIT
S
Recharge the battery as soon as the cutting
power of your cordless trimmer is no longer
effective.
S
Avoid running the battery into full dis-
charge, i.e. avoid draining the battery com-
pletely.
S
Follow the procedure outlined in the
CHARGING YOUR UNIT section.
S
Recharging the battery according to these
instructions should ensure maximum bat-
tery life.
S
Do not recharge the battery in an area of ex-
treme heat or cold. It will work best at nor-
mal room temperature.
CORRECT OPERATING POSITION
Trimming
Edging
WARNING:
Always wear eye protec-
tion. Never lean over the trimmer head.
Rocks or debris can ricochet or be thrown into
eyes and face and cause blindness or other
serious injury.
When operating unit, stand as shown and
check for the following:
S
Wear eye protection and heavy clothing.
S
Hold trigger handle with right hand and as-
sist handle with left hand.
S
Keep unit below waist level.
S
Cut only from your right to your left to en-
sure debris is thrown away from you. With-
out bending over, keep line near and paral-
lel to the ground and not crowded into
material being cut.
AUTOMATIC LINE FEED SYSTEM
When the trimmer is initially started, a small
length of cutting line is fed out.
Line Limiter Pin
After approximately 5 seconds, the line will be
cut to the correct length by the line limiter pin
as the motor reaches full speed.
Make sure
the motor is up to full speed before trim-
ming.
If the noise of the cutting line being cut
cannot be heard, more line will need to be fed
out.
To feed more line:
S
Allow the motor to stop completely; then, re-
start the motor and allow it to reach full
speed.
S
Repeat until you hear the line hitting against
the line limiter pin (do not repeat this proce-
dure more than 6 times).
If problems are experienced with the auto-
matic line feed, refer to the TROUBLE-
SHOOTING TABLE.
To manually feed the nylon line:
S
If required, the cutting line can be fed out
manually.
S
To operate, press and release manual line
feed button while gently pulling on one of
the line until it reaches the line limiter pin.
Manual Line
Feed Button
S
If the line extends past the line limiter pin,
too much line has been fed out. If too much
line is fed out, remove the spool cap and
click spool counterclockwise until the line is
at the desired length.
