5
ASSEMBLY
WARNING:
Stop the unit and dis-
connect from the power source before
opening the vacuum inlet cover. The mo-
tor must be stopped and the impeller
blades no longer turning to avoid serious
injury from the rotating blades.
WARNING:
If received assembled,
ensure your unit is properly assembled
and all fasteners are secure.
S
A standard screwdriver is required for
assembly.
Your blower can also be used as a
vacuum by purchasing an optional
vacuum kit (Model EBVA 1910). Con-
tact your authorized service dealer
for details.
BLOWER TUBE ASSEMBLY
1. Align the grooves on the blower tube
with the grooves on the blower outlet.
2. Push the blower tube onto the blower
outlet until it snaps into place (tube is
secured by red tube release button).
3. To remove the blower tube, press the
tube release button while pulling on
tube.
Blower Tube
Tube Release Button
Blower outlet
SELECT AN EXTENSION CORD
Use only a 120 A.C. voltage supply as
shown on nameplate of the unit to
power your blower.
The extension cord used to reach the
power source must be:
D
Specifically marked as suitable for out-
door use. The cord must be marked with
the suffix “W”.
D
Heavy enough to carry full current from
the power source to the unit. Otherwise,
loss of power and overheating can oc-
cur causing damage to unit. Refer to
table for minimum wire gauge recom-
mendations. The cord must be marked
with the proper wire gauge. (Appropriate
extension cords are available.) Do not
use multiple cords.
D
In good condition. Cord insulation must
be intact with no cracks or deterioration.
Plug connectors must be undamaged.
DO NOT
use multiple cords.
MINIMUM WIRE GAUGE
RECOMMENDATIONS
VOLTS
25 FT.
50 FT.
100 FT.
120
16
A.W.G.*
16
A.W.G.*
*American Wire Gauge
14
A.W.G.*
Secure the extension cord to the unit by
threading the cord through the cord re-
tainer (see illustration). Insert the cord
receptacle into the recessed plug.
CAUTION:
Failure to use cord retain-
er could result in damage to the unit,
extension cord, or both.
Cord
Retainer
Cord
Receptacle
Recessed
Plug
on Unit
