background image

9

Fuel stabilizer is an acceptable alternative in
minimizing the formation of fuel gum deposits
during storage. Add stabilizer to the gasoline
in the fuel tank or fuel storage container. Fol-
low the mix instructions found on stabilizer
container. Run engine at least 5 minutes after
adding stabilizer.

ENGINE

S

Remove spark plug and pour 1 teaspoon of
40:1, 2-cycle engine oil (air cooled) through
the spark plug opening. Slowly pull the
starter rope 8 to 10 times to distribute oil.

S

Replace spark plug with new one of recom-
mended type and heat range.

S

Clean air filter.

S

Check entire unit for loose screws, nuts,
and bolts. Replace any damaged, broken,
or worn parts.

S

At the beginning of the next season, use
only fresh fuel having the proper gasoline to
oil ratio.

OTHER

S

Do not store gasoline from one season to
another.

S

Replace your gasoline can if it starts to rust.

TROUBLE

CAUSE

REMEDY

Engine will not
start.

1. Engine flooded.

2. Fuel tank empty.
3. Spark plug not firing.
4. Fuel not reaching

carburetor.

5. Carburetor requires

adjustment.

1. See “Starting a Flooded Engine” in

Operation Section.

2. Fill tank with correct fuel mixture.
3. Install new spark plug.
4. Check for dirty fuel filter; replace.

Check for kinked or split fuel line;
repair or replace.

5. Contact an authorized service dealer.

Engine will
not idle
properly.

1. Carburetor requires

adjustment.

2. Crankshaft seals worn.
3. Compression low.

1. See “Carburetor Adjustment” in

Service and Adjustments Section.

2. Contact an authorized service dealer.
3. Contact an authorized service dealer.

1. Air filter dirty.
2. Spark plug fouled.

3. Carburetor requires

adjustment.

4. Carbon build-up on

muffler outlet screen.

5. Compression low.

Engine will not
accelerate,
lacks power,
or dies under
a load.

1. Clean or replace air filter.
2. Clean or replace plug

and regap.

3. Contact an authorized service dealer.

4. Contact an authorized service dealer.

5. Contact an authorized service dealer.

Engine
smokes
excessively.

1. Choke partially on.
2. Fuel mixture incorrect.

3. Air filter dirty.
4. Carburetor requires

adjustment.

1. Adjust choke.
2. Empty fuel tank and refill with

correct fuel mixture.

3. Clean or replace air filter.
4. Contact an authorized service dealer.

Engine runs
hot.

1. Fuel mixture incorrect.

2. Spark plug incorrect.
3. Carburetor requires

adjustment.

4. Carbon build-up on

muffler outlet screen.

1. See “Fueling Engine” in Operation

section.

2. Replace with correct spark plug.
3. Contact an authorized service dealer.

4. Contact an authorized service dealer.

WARNING:

Always stop unit and disconnect spark plug before performing all of the

recommended remedies below except remedies that require operation of the unit.

TROUBLESHOOTING TABLE

Summary of Contents for 530163346












Reviews: