WECO 5K3 LV/HV
71
3.6.1
LED Visual Indication Lights
•
Power Button
•
Each Battery Module has its own power button, however, when used with the HV Box
during normal operation, the power button function has no purpose and is bypassed by the
control communications from the HV Box.
Caution:
In the HV configuration, the power button will have no effect on the operation of the Battery Module
and the operator should not assume that the power button will have switched off the Battery Module when
pressed.
3.6.1.1
Power Button
The Power Button is located to the right of the battery terminal connections on the side of the Battery Module. The Power Button
is a multi-color button and will provide the user with the following indications depending on the state of the battery.
A 2-second press on the Power Button will turn the Battery Module on.
A 5-second press on the Power Button will turn the Battery Module off.
Other functions of the Power Button are explained in the relevant sections of this manual.
Attention:
Read this entire manual thoroughly to understand the correct startup and shutdown procedures for
each battery configuration.
Attention:
Illustrations shown are for reference only. Please always refer to the physical Battery Module in front
of you, and if the module has a different configuration to this manual, stop all activity immediately and contact your
WeCo Module technical representative.
3.6.2
Stand-Alone Battery Front Panel Control * FORCED CHARGE*
3.6.2.1
Start Battery
Press the Power Button of the HV Box for 3 or more seconds (depends on the system status).
The GREEN RUN light should come on. The HV Box module has been activated normally and the Battery Modules should come
on automatically. If they do not, press the RUN Button of each module and wait for the HV Box string diagnosis. If the HV Box
shows a warning LED light (RED), turn the string OFF and connect the PC software for debugging.
3.6.2.2
Shut Down Batteries and HV Box
Long press the Power Button for five seconds and the Run Button on the HV Box.
The GREEN RUN light should go off. The HV Box has been shut down normally.
By switching off the HV Box, all the Battery Modules should turn off automatically. If they do not, shut down manually by
pressing and holding the Run Button for 5 seconds.
Summary of Contents for UNIVERSAL 5K3HV
Page 70: ...WECO 5K3 LV HV 70 3 6 HV Box ADDRESS...
Page 75: ...WECO 5K3 LV HV 75...
