WebPort 2001
Installation Guide
page 8
ver 2.02
3.5 Mechanical outline
Figure 5: Mechanical outline
Figure 6: DIN-rail latch
The WebPort must be fastened on a 35mm DIN rail compliant with EN50022. A fixing latch is therefore fastened at
the bottom of the housing in order to put the device in place or remove it.
To put the unit in place, insert the top slider into the upper part of the rail, with the WebPort tilted around 20°. Then
draw the latch at the bottom downwards with a screwdriver and at the same time put the unit right by rotating it.
Release the pin, the WebPort is now safely fastened.
Important: Be careful when mounting the unit on the DIN-rail as doing it improperly could damage either
the fixing latch and/or the DIN-rail itself.