12
VEHICLE SIGNAL BOOSTER
DRIVE REACH
Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without
factory reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order
to increase coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a
signal is detected. If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster
will automatically turn the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal
operation after a minimum of 1 minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the
Signal Booster has been manually restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity
are maintained by the Signal Booster’s microprocessor.
This device complies with Part 15 of FCC rules. Operation is subject to two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by weBoost could void the authority to operate this equipment.
______
Specifications
Drive Reach
Model Number
460061
FCC ID
PWO460061
Connectors
SMB-Jack
Antenna Impedance
50 Ohms
Frequency
698-716 MHz, 728-756 MHz, 777-787 MHz, 824-894 MHz, 1850-1995 MHz, 1710-1755/2110-2155 MHz
Maximum Power
Power output for single cell
phone (Uplink) dBm
700 MHz
Band 12/17
25.4
700 MHz
Band 13
25.6
800 MHz
Band 5
25.6
1700 MHz
Band 4
26.7
1900 MHz
Band 2/25
26.9
Power output for single cell
phone (Downlink) dBm
700 MHz
Band 12/17
4.8
700 MHz
Band 13
4.8
800 MHz
Band 5
4.8
2100 MHz
Band 4
4.6
1900 MHz
Band 2/25
4.5
Noise Figure
5 dB nominal
Isolation
> 90 dB
Power Requirements
12V 1.75A
