weBoost Drive Reach RV, Installation Manual

Page: 12 / 40

10 ENGLISH
FIXING BLINKING OR RED LIGHT ISSUES
This section is only applicable if the Booster is red or blinking red and you are not
experiencing the desired signal boost.
1 Unplug the Booster’s power supply .
2 Relocate the inside and outside antenna further from each other . The objective is
to increase the separation distance between them, so that they will not create this
feedback condition discussed before .
3 Plug Power Supply back in .
4 Monitor the indicator light on your Booster . If, after a few seconds of ‘power
on’, a solid or blinking red light appears, repeat steps 1 through 3 . Increase the
separation distance until the condition is corrected and/or desired coverage area
is achieved . Note: Horizontal separation of the two antennas typically requires a
shorter separation distance than vertical separation .
If you are having any difficulties while testing or installing your Booster, contact our
weBoost Customer Support team for assistance (866 .294 .1660) .
Troubleshooting