weBoost Connect 4G 470003 Installation Instructions Manual Download Page 11

11

Need help?

www.weboost.com

Customer Support  866-294-1660

Mon.- Fri. Hours: 7 am to 6 pm MST

ENGLISH

Lightning

Surge Protector

(sold separately)

To Outside

Antenna

To Signal Booster

Ground Wire

(not included)

!

RECOMMENDED  INSTALLING THE LIGHTNING SURGE PROTECTOR 

(SOLD SEPARATELY)

INSTALL THE LIGHTNING SURGE PROTECTOR (LSP) CLOSE TO THE SIGNAL 

BOOSTER. ATTACH THE CABLE FROM THE OUTSIDE ANTENNA TO THE 

SURGE PROTECTOR. 

ENSURE THE LSP IS PROPERLY GROUNDED

.

  

#859992-75 OHM MAY BE PURCHASED AT 

WWW.WEBOOST.COM

 OR BY 

CALL NG 800-204-4104.

Signal Booster Specifications

 

 

Connect 4G

Model Number

470003

Connectors

F-Female

Antenna Impedance

50 Ohms

Frequency

704-746 MHz, 746-787 MHz, 824-894 MHz,  1850-1995 MHz,  1710-1755/2110-2155 MHz

Passband Gain (nominal)

700 MHz

Band17

57.3

700 MHz

Band13

55.0

800 MHz

Band 5

57.2

1700/2100 MHz 

Band 4

60.5

1900 MHz

Band 25/2

57.0

20 dB Bandwidth (MHz)

700 MHz

Band17

700 MHz

Band13

800 MHz

Band 5

1700/2100 MHz

Band 4

1900 MHz

Band 25/2

Typical

Maximum

26.2

29.8

26.7

29.8

38.3

39.5

73.5

73.8

78.4

80.1

Power output for single cell 

phone (Uplink) dBm

700 MHz Band17

Band17

700 MHz Band13

Band13

800 MHz

Band 5

1700 MHz

Band 4

1900 MHz

Band 25/2

23.7

23.6

24.6

24.9

23.3

Power output for single cell 

phone (Downlink) dBm

700 MHz Band17

Band17

700 MHz Band13

Band13

800 MHz

Band 5

2100 MHz

Band 4

1900 MHz

Band 25/2

0.9

-1.0

2.1

5.8

6.1

Power output for multiple 

received channels (Uplink) dBm

No. Tones

Maximum Power

700 MHz Band17

Band17

700 MHz Band13

Band13

800 MHz

Band 5

1700 MHz

Band 4

1900 MHz

Band 25/2

2

21.3

20.7

23.0

19.9

18.1

3

17.7

17.2

19.4

16.4

14.6

4

15.2

14.7

16.9

13.9

12.1

5

13.3

12.8

15.0

11.9

10.2

6

11.7

11.2

13.4

10.4

8.6

Power output for multiple 

received channels 

(Downlinklink) dBm

Maximum Power

No. Tones

700 MHz

Band17

700 MHz

Band13

800 MHz

Band 5

2100 MHz

Band 4

1900 MHz

Band 25/2

2

-2.0

-3.2

1.8

-0.5

-2.2

3

-5.6

-6.7

-1.7

-4.1

-5.8

4

-8.1

-9.2

-4.2

-6.6

-8.3

5

-10.0

-11.2

-6.1

-8.5

-10.2

6

-11.6

-12.8

-7.7

-10.1

-11.8

Noise Figure

7 dB nominal

Isolation

> 110 dB

Power Requirements

AC / DC 5V, 2.5A, w/2.5x5.5mm Jack

Each Signal Booster is individually tested and factory set to ensure FCC compliance. The Signal Booster cannot be adjusted without factory 

reprogramming or disabling the hardware. The Signal Booster will amplify, but not alter incoming and outgoing signals in order to increase 

coverage of authorized frequency bands only. If the Signal Booster is not in use for five minutes, it will reduce gain until a signal is detected. 

If a detected signal is too high in a frequency band, or if the Signal Booster detects an oscillation, the Signal Booster will automatically turn 

the power off on that band. For a detected oscillation the Signal Booster will automatically resume normal operation after a minimum of 1 

minute. After 5 (five) such automatic restarts, any problematic bands are permanently shut off until the Signal Booster has been manually 

restarted by momentarily removing power from the Signal Booster. Noise power, gain, and linearity are maintained by the Signal Booster’s 

microprocessor.

The Manufacturer’s rated output power of this equipment is for single carrier operation. For situations when multiple carrier signals are 

present, the rating would have to be reduced by 3.5 dB, especially where the output signal is re-radiated and can cause interference to 

adjacent band users. This power reduction is to be by means of input power or gain reduction and not by an attenuator at the output of the 

device.

Summary of Contents for Connect 4G 470003

























Reviews: