
34
Operating Instructions
Lighting
Summary lighting instructions are on the control panel.
DANGER
Failure to open the lid while igniting the
barbecue’s burners, or not waiting 5
minutes to allow the gas to clear if the
barbecue does not light, may result in an
explosive flare-up which can cause serious
bodily injury or death.
Crossover
®
Ignition System
Note - The Crossover
®
ignition system ignites the set of
left burners with a spark from the igniter electrode
inside the Gas Catcher™ ignition chamber. You
generate the energy for the spark by pushing the
Electronic ignition button until it clicks.
WARNING: Check hose before each use of
barbecue for nicks, cracking, abrasions or cuts. If
the hose is found to be damaged in any way, do
not use the barbecue. Replace using only Weber
®
authorised replacement hose. Contact the
Customer Service Representative in your region
using the contact information sheet provided with
your manual.
1
7
2
3
6
4,5,8
2
*The grill illustrated may have slight differences than the
model purchased.
1) Open the lid.
2) Make sure all burner control knobs are turned OFF.
(Push control knob down and turn anticlockwise to
ensure that it is in the OFF position.)
WARNING: The burner control knobs must be in the
OFF position before turning on the liquid propane
cylinder tank valve.
3) Turn the cylinder on by turning the cylinder valve
anticlockwise.
WARNING: Do not lean over the open barbecue
.
4) Select the burner set you want to operate.
5) Push LEFT burner control knob down and turn to
START/HI in selected burner set.
6) Push igniter button and hold until burner ignites. You
will hear the igniter sparking.
7) Check that the burner is lit by looking through the
cooking grates. You should see a flame.
WARNING: If the burner does not light, turn the
LEFT burner control knob to OFF and wait 5
minutes to let the gas clear before you try again or
try to light with a match.
8) After the LEFT burner is lit you can turn on the RIGHT
burner adjacent to it. The RIGHT burner lights from the
LEFT burner.
To Extinguish
Push down and turn each burner control knob
clockwise to the OFF position. Turn gas supply OFF at
the source.
Summary of Contents for Summit Gold D 42080
