31
Figure 41
Figure 42
Position slide bar assembly on the outside of the wheel
frame. Put a nylon washer on each 1 3/4 inch screw,
insert screws through frame and slide bar assembly and
add nylon washers and hex nuts. Tighten nuts using a
screwdriver and pliers. Figure 41.
To lower table: Pull support rod up to disengage slide
lock and lower table. To raise table, lift table up and
engage slide in locked position. Figure 42.
Notch to the front
Slide bar
Support rod
Unlocked position
Slide
Support rod
Locked position
View from front of barbecue
Figure 40
View from rear
of barbecue
Hinge rod
Slot in frame
(view from below)
Insert one end of the hinge rod into the hole in the
frame. Figure 40 (a).
Insert the other end into the hole in the swing table end
bracket. Figure 40 (b). Hold the end bracket at an angle so
the lower tab is inside the frame tube. Push the bracket into
the frame. Check to see that the lower tab of the bracket is
hooked in the slot in the frame. Figure 40 (c).
To fully seat the bracket, you may have to tap it lightly with a
hammer.
WARNING: If swing table end bracket is in any
way cracked or damaged, do not use swing table.
Call our Customer Service Center to order a new
part.
WARNING: The load limit for the swing table is
30 pounds.
(b)
(c)
(a)
