14
SM62-2
1
Replacing the cutting disc
Lift the cutting disc protection (1) to the highest position using the
cutting depth adjustment lever
Remove the protective cap (1).
Push 6 mm round steel (1) into the opening.
Put the hollow hexagon wrench (2) onto the clamping bolt (1) and
rotate the cutting shaft slowly until you feel the 6 mm round steel
engage.
Unscrew the clamping bolt (1).
Clean the holding flange (3) thoroughly.
Install new cutting disk.
Remove the round steel (1) to close the cutting disc protection
with the protective cap.
1
2
1
Only use suitable cutting discs.
Installation is performed in the reverse order of removal. The
following points have to be observed:
The installation of the cutting disc always has to be carried out
in accordance with the direction arrow on the cutting disc, i.e.
the arrows on the cutting disc and the cutting disc protection
have to point in the same direction.
The cutting disc has to be secured backlash-free on the holding
flange and never on the thread.
The support surface of the holding flange and the clamping
bolt must be free of notches and any other damage. If this is
not the case, then damage can occur and the diamond disc
can fail prematurely.
Screw on clamping bolt tightly.
Put hollow hexagon wrench in the holder provided.
1
2
3
Summary of Contents for SM 62-2
Page 2: ...2 SM62 2...
