Weber mt SM 57-2, Operating And Maintenance Manual

Page: 13 / 24

13
Bring the gas lever (1) into full-throttle position.
Slide the choke lever (2) to the left (close).
Open the fuel cock (3).
Starting
Turn the short-circuit button to the „ON position.
Set cutting depth with the tommy screw (1) at the adjusting
spindle (2).
The cutting depth is only permitted to be set when the
engine is not running.
Setting the height of the manual guidance rod
Unscrew adjusting screw (1), pull up manual guidance rod
until it is at the required working height.
Secure manual guidance rod with adjusting screw (1).
Setting the cutting depth
Mounting the cutting disk
Comply with the direction of rotation of the diamond disk
(arrow marking).
The holding flange must be completely free of rust, sawing
sludge, and the like. Clean before changing blade.
Ensure that the support surface of the flange does not
have any notches or other damage because they would
cause the blade to wobble upon mounting.
Remounting the diamond disk occurs in the reverse order
to dismounting.
After mounting the diamond disk, tighten fastening screw
with a powerful jerk.
1
1
2
1
2
3
3
Release fastening screw (1) with a jerk and screw out.
Remove clamping flange (2) and cutting disk (3) from
the locating pin and take out from the bottom.