16
CR 9 CCD 2.0
1
1
3
2
4
5
6
7
8
1
Mounting the attachment plates
Tighten the screws of the attachment plates with a torque
of 425 NM.
Starting
Open the vandalism flap (1).
Bring the gas lever into full-throttle position.
If the ignition key does not bounce back to pos. 1 – turn
off the machine immediately – danger of starter damage
due to the starter also running during operation.
Start for a maximum of 20 seconds without interruption.
If the engine does not start, repeat starting process af-
ter a minute. If the engine does not start after two start
processes, seek cause in fault table.
Once the ignition is switched on, the COMPATROL
®
compaction system will perform a function test. All LEDs (1)
light up.
Insert the ignition key (1) and turn to position 1.
10 hours prior to the next scheduled maintenance the LED (2)
lights up permanently.
The display will indicate the operating hours that have passed
since the last maintenance.
Turn the ignition key (1) to position 2.
Release the ignition key as soon as the engine starts.
The ignition key must bounce back to pos. 1 and remain
in this position during operation. The charge level (3),
temperature (4), filter (5) and oil pressure indicator (6)
must go out immediately after starting.
The LED indicator (7) lights up, indicating that the engine is
in operation.
The operating hours counter (8) will keep counting the
operating hours as long as the ignition is switched on.
Summary of Contents for CR 9 CCD 2.0
Page 2: ...2 CR 9 CCD 2 0...
