Weber mt CR 5 E, Operating And Maintenance Manual

Page: 13 / 24

CR5E 13
Starting
Bring the gas lever into full-throttle position.
Check the hydraulic oil level when the machine is at operating
temperature. The correct oil level is reached when the oil is in
the middle of the view glass.
Tighten the screws (1) of the attachment plates (2) with a
torque of 310 NM.
Checking the hydraulic fluid level
Mounting the attachment plates
Mounting the Poly pad
Fasten the Poly pad with holder, screws, spring-lock washers
and nuts on the base plate front and rear.
Ensure that the Poly pad rests under the base plate.
Insert the ignition key (1) and turn to position 1
Turn the ignition key (1) to position 2
Release the ignition key as soon as the engine starts
Symbols (2, 5, or 6) are not assigned.
For emergency start with reversing starter, precisely follow
the instructions provided by the engine manufacturer.
1
2
3
4
5
6
Start for a maximum of twenty seconds without interrup-
tion. If the engine does not start, repeat starting process
after a minute. If the motor does not start after two start
processes, seek cause in fault table.
1
2
If the ignition key does not automatically return into position
1, put the machine out of operation - risk of starter dama-
ge because of starter working during machine operation.