Weber mt CR 3-II E, Operating And Maintenance Manual

Page: 15 / 28

CR 3-II E 15
1
2
3
4
5
6
7
8
Checking the hydraulic oil level
Check the hydraulic oil level when the machine is at operating
temperature. The guide bar must be in the transport position –
i.e. folded up. The correct oil level is reached when the oil is in
the middle of the view glass.
Mounting the attachment plates
Tighten the screws (1) of the attachment plates (2) with
a torque of 310 Nm.
Installing the protective mat
Fasten the protective mat with holder, screws, spring-lock
washers and nuts on the base plate front and rear.
Ensure that the protective mat rests under the base plate.
Starting
Bring the gas lever into full-throttle position.
Insert the ignition key (3) and turn to position 1.
Turn the ignition key (3) to position 2.
Release the ignition key as soon as the engine starts.
The charge level indicator (5) and the oil pressure indica -
tor (4) must go out immediately after starting.
Symbols (4, 7, or 8) are not assigned.
Start for a maximum of 20 seconds without interruption.
If the engine does not start, repeat starting process
after a minute. If the engine does not start after two
start procedures, look for the cause in the fault table.
If the ignition key does not spring back to pos. 1 – turn
off the machine immediately – danger of starter damage
due to the starter also running during operation.