47
- Turn off the appliance and unplug it.
- Clean the air filter according to the instructions in the previous section. Reinstall
the clean, dry filter before storing.
- Remove the batteries from the remote control.
NOTE:
Be sure to store the unit in a cool, dark place. Exposure to direct sunshine
or extreme heat can shorten the lifespan of the unit.
NOTE:
The cabinet and front may be dusted with an oil-free cloth or washed with
a cloth dampened in a solution of warm water and mildliquid dishwashing deter-
gent. Rinse thoroughly and wipe dry. Never use harsh cleansers, wax or polish on
the cabinet front. Be sure to wring excess water from the cloth before wiping
around the controls. Excess water in or around the controls may cause damage to
the unit.
E
TROUBLESHOOTING TIPS
Problem
Possible causes
Solution
Unit does not
turn on when
pressing ON/
OFF
button
P1 Error Code
The Water Collection Tray is full. Turn
off the unit, drain the water from the
Water Collection Tray and restart the
unit.
In COOL mode: room temperature is
lower than the set temperature
Reset the temperature
E0 EEPROM error
Contact the manufacturer or its service
agents or a similar qualified person for
service.
Unit does not
cool well
The air filter is blocked with dust
or animal hair
Turn off the unit and clean the filter
according to instructions
Exhaust hose is not connected or
is blocked
Turn off the unit, disconnect the hose,
check for blockage and reconnect the
hose
The unit is low on refrigerant
Call a service technician to inspect the
unit and top off refrigerant
Temperature setting is too high
Decrease the set temperature
The windows and doors in the
room are open
Make sure all windows and doors are
closed
The room area is too large
Double-check the cooling area
There are heat sources inside the
room
Remove the heat sources if possible
The unit is
noisy and
vibrates too
much
The ground is not level
Place the unit on a flat, level surface
The air filter is blocked with dust
or animal hair
Turn off the unit and clean the filter
according to instructions
The unit
makes a
gurgling
sound
This sound is caused by the flow
of refrigerant inside the unit
This is normal
man_WP0115-SCAN ('20) V1.indd 47
man_WP0115-SCAN ('20) V1.indd 47
14-12-20 10:00
14-12-20 10:00
